Libraries: Reconfiguration – CANopen Local Device (Slave) 3S CANopenSlave Stack 3S CANopenSafety Slave :
J1939 J1939 is a CAN-based protocol (CAN stands for "Controller Area Network"). It was developed for serial data transmission between electronic control units (ECU) in heavy goods vehicles. The CODESY
General The J1939 Manager is inserted in the device tree below the CAN bus node. It provides the J1939 parameter groups and signal database. The ECUs are inserted below the J1939 Manager. The Scan Dev
Configuration Tip See the general description for information about the following tabs of the device editor. Tab: <device name> I/O Mapping Tab: <device name> IEC Objects Tab: <device name> Parameters
on the Vehicle system . The 4
Tab: J1939-ECU – TX Signals This dialog shows the parameter groups that are transmitted to all other ECUs (broadcast) or to a specific ECU (P2P). In this dialog, you can activate and deactivate indivi
Tab: J1939-ECU – P2P RX Signals This dialog is available for local ECUs only. It shows all PGs (parameter groups) that should be received by other ECUs. In this dialog, individual groups can be activa
Dialog: Add Parameter Group Tip In CODESYS version 3.5 SP17 and higher, the J1939 configurator is no longer supplied with a parameter group / signal database. The old database is no longer supported.
Dialog: Add Signal Tip In CODESYS version 3.5 SP17 and higher, the J1939 configurator is no longer supplied with a parameter group / signal database. The old database is no longer supported. However,
